订书机常见故障排除及修理技巧 一、常见故障 1. 卡纸：这是订书机最常见的故障之一。当纸张在订书过程中卡住，导致订书机无法正常工作。 2. 订书针弯曲或断裂：使用过程中，订书针可能会因为过度用力或其他原因而弯曲或断裂。 3. 订书机不吸纸：有时候订书机无法正常吸取纸张进行订书。 4. 滑轨松动：长期使用后，订书机的滑轨可能会松动，导致订书不准确。 二、故障排除及修理技巧 1. 卡纸问题 （1）首先检查是否有纸张卡在订书机内部，若有，则小心取出。 （2）检查订书机的弹簧和铁片是否正常，如有异常则需更换。 （3）清理订书机内部的灰尘和纸屑，保持机器内部清洁。 （4）调整订书机的压力，使其适中，避免因压力过大导致卡纸。 2. 订书针弯曲或断裂 （1）更换新的订书针。 （2）检查是否使用正确型号的订书针。 （3）使用时避免过度用力，以防止订书针再次弯曲或断裂。 3. 订书机不吸纸

（1）检查纸张是否放置正确，是否符合订书机的吸纸要求。

【订书机】得力迷你小号订书机订书器学生用便钉捷小款书机多功能订书装新品售价：56.68元 领券价：56.68元 邮费：25.00

（2）清理吸纸口和内部的灰尘和纸屑，保持通畅。 （4）调整订书机的感应器，确保其正常工作。 4. 滑轨松动 （1）检查滑轨的固定螺丝是否松动，若松动则拧紧。 （2）若滑轨磨损严重，则需要更换新的滑轨。 （3）保持订书机的日常清洁和润滑，以延长其使用寿命。 三、英文翻译 Common Faults and Repair Skills of Bookbinding Machines I. Common Faults 1. Paper jam: This is one of the most common faults of bookbinding machines. When the paper gets stuck in the process of bookbinding, it will cause the machine to malfunction. 2. Bent or broken binding needles: During use, binding needles may become bent or broken due to excessive force or other reasons. 3. Bookbinding machine does not suck paper: Sometimes the bookbinding machine cannot normally suck in the paper to be bound. 4. Loose sliding rail: After long-term use, the sliding rail of the bookbinding machine may become loose, resulting in inaccurate binding. II. Troubleshooting and Repair Skills 1. Paper jam problem: (1) First check if there is paper stuck inside the bookbinding machine, and if so, carefully remove it. (2) Check if the spring and iron piece of the bookbinding machine are normal, and replace them if abnormal. (3) Clean the dust and paper debris inside the bookbinding machine to keep the inside clean. (4) Adjust the pressure of the bookbinding machine to be moderate to avoid paper jam caused by excessive pressure. 2. Bent or broken binding needles: (1) Replace the new binding needle. (2) Check if you are using the correct type of binding needle. (3) Avoid excessive force during use to prevent the binding needle from bending or breaking again. 3. Bookbinding machine does not suck paper: (1) Check if the paper is placed correctly and meets the suction requirements of the bookbinding machine. (2) Clean the suction port and inside to keep it unblocked. (4) Adjust the sensor of the bookbinding machine to ensure its normal operation.

【订书机】晨光省力型订书机91639大号学生办公订书用机标准钉耐用实用新款售价：5.90元 领券价：5.9元 邮费：0.00

4. Loose sliding rail: (1) Check if the fixing screw of the sliding rail is loose, and tighten it if necessary. (2) If the sliding rail is severely worn, replace it with a new one. (3) Keep the daily cleaning and lubrication of the bookbinding machine to extend its service life.